Hi-Tech Fasteners Inc.
Hi-Tech Fasteners, Inc.
4940 Winchester Boulevard
Frederick, Maryland 21703-7400

Toll Free: 800.466.1940
Tel: 301.831.1277
Fax: 301.831.8296
Email: sales@hitechfasteners.com
Website: www.hitechfasteners.com
Print Back
These standoffs ensure permanent mounting in metal sheets as thin as .062 in.

The fastener head is locked securely in a blind, milled hole and is able to handle substantial loads. The concealed-head feature allows the side of the sheet opposite installation to remain smooth.

Sheet preparation only requires a milled blind hole to the recommended minimum depth. Center-cutting end mills for hole preparation are available from PennEngineering. Installation of the concealed-head studs and standoffs is simple using a hollow anvil and solid punch. Place the head of the fastener in the hole and insert using any standard press. Displaced sheet metal flows smoothly around the head into the undercut.
Unit of Measure

Specifications

Thread Size

 N/A .250-20 (1/4-20)

Thread Code

 N/A 0420

Length Code

 N/A 5

Material Code

 N/A S

Style

 N/A #1

Shank

 N/A Short

Min. Sheet Thickness

 N/A .062 in

Blind Mounting Hole Diameter + .003 - .000

 N/A .390 in
Min. Depth of Blind Hole1 N/A .043 in
L - Length + .002 –.0052 N/A .312 in a1391_1.jpg

A Max.

 N/A .041 in
B Max.3 N/A .354 in

C Max.

 N/A .389 in

H Nom.

 N/A .438 in a1394_1.jpg
Min. Dist. Hole C/L to Edge4 N/A .375 in

For Use in Sheet Hardness

 N/A HRB 70 / HB 125 or Less

Thread Specification

 N/A Internal, ANSI B1.1, 2B

Fastener Material

 N/A 300 Series Stainless Steel

Standard Finish

 N/A Passivated and/or tested per ASTM A380

CAD Supplier

 N/A PennEngineering® (PEM®)

Min. Depth Full Thread F

 N/A .375 in

Inventory

 N/A {0}
  • 1 Blind mounting holes may be deeper than minimums except where sheet material is at or near minimum thickness. Fasteners should always be installed so the flange is flush with the surface of the sheet.
  • 2 The “L” dimension is the height of the installed stud at max grip. The height of the stud will increase if it is installed into thinner material. To calculate “actual L” use this formula: max grip - actual grip + L = “actual L”
  • 3 If standoff is used as a bushing, the hole in attached part must not exceed “B” plus .020” / 0.51 mm.
  • 4 To minimize sheet distortion and maximize product performance, use a centerline-to-edge value greater or equal to the value specified.