Search our PEM catalog here, or view other manufacturers.

  1. Manufacturers
  2. Services
  3. About Us
  4. What’s New
  5. Careers
  6. Contact
  7. Search

Product Catalog

Tel 800.466.1940
Batch CAD Cart (0) ▾
  • Cart is empty
  1. Request CAD files
Request Information Add to CAD Cart
  • Installs into thinner, harder, high strength steel materials (high strength steel sheets up to 700 MPa maximum ultimate tensile)
  • Allows overall weight reduction for all vehicles
  • Provides lower installed cost
Compare to other thin sheet fastening devices:
  • Addresses environmental concerns
  • Lighter weight
  • Close to edge of panel mounting
  • No embossing required
  • Hardened stud material provides stronger thread strength
  • Can be installed automatically using press or in-die technology
Unit of Measure

Thread Size

 N/A .190-32 (#10-32)

Thread Code

 N/A 032

Length Code

 N/A 12

Min. Sheet Thickness

 N/A .040 in

Hole Size in Sheet + .005 - .000

 N/A .190 in
L - Length ± .0151
N/A .750 in Type-HFL-Hard-Panel-Studs_2_1.jpg

H ± .01

 N/A .357 in
S Max.2 N/A .102 in

T Max.

 N/A .048 in

Max. Hole in Attached Parts

 N/A .280 in
Min. Dist. Hole C/L to Edge3 N/A .360 in

Tensile strength

 N/A 120 ksi
For Use in Sheet Hardness4 N/A HRB 96 / HB 216 or Less

Thread Specification

 N/A External, ASME B1.1, 2A / ASME B1.13M, 6g

Fastener Material

 N/A Heat-Treated Alloy Steel
Optional Finish5 N/A No Finish (with Rust Preventative Oil)

CAD Supplier

 N/A PennEngineering® (PEM®)

Inventory

 N/A {0}
  • 1 The “L” dimension is the height of the installed stud at max grip. The height of the stud will increase if it is installed into thinner material. To calculate “actual L” use this formula: max grip - actual grip + L = “actual L”
  • 2 Threads are gageable to within 2 pitches of the "S" Max. dimension. A class 3B/5H maximum material commercial nut shall pass up to the "S" Max. dimension.
  • 3 To minimize sheet distortion and maximize product performance, use a centerline-to-edge value greater or equal to the value specified.
  • 4 HRB - Hardness Rockwell "B" Scale. HB - Hardness Brinell
  • 5 “X” suffix studs may have pitch diameters and major diameters below 2A “Basic”, per ANSI B1.1, Section 7, and B1.13M, Section 8 to allow for minimum of 0.0002” / 0.0051 mm of plating.